| |
 |
Download Software Fad V4.0
Full installation (1.7Mb)
Some costumers have had their antivirus give a
false positive on this file. If this is your
case, download this file and unzip it. You will
need to run the setup.exe. |
|
|
|
|
Download Software Fad V4.0
Autoexecutable file(1Mb)
(USB Compatible. Updated 19/07/2007)
Auto executable file.
Download the file and unzip it. Launch the
executable file. This software does not need
installation. |
| |
|
|
Download USB Drivers Fad V4.0
Full installation (1.7Mb)
To download the information to the software you
will need an RS232 or USB interface. If you are
using a Xicoy Electrónica FADEC USB Cable or any
other USB cable, use the following USB Drivers. |
| |
Connection of the
FADEC to the PC:
|
|
  1) If you use
a RS232 cable connected directly to a Comm port
on the PC: |
|
   - Connect your
fadec to a free RS232 port on your computer.
|
|
   -Power on the
FADEC (using a RX battery and receiver), and
select the apropiate COMM port in the menus.
|
|
   -Once you
select the appropriate COMM port, the software
will display "Fadec connection OK". |
| |
|
  Â
2) If you use a RS232 cable connected
to a third party USB-RS232 adapter:
|
   - Install the
software received with your USB-RS232 adapter,
and follow the manufacturer instructions. Check
that in the
Windows Control Panel, your USB- RS232 adapter
is correctly installed and its port number is
between 1 and 8. |
|
   -Connect your
fadec to your USB-RS232 adapter, and the USB
adapter to the PC. |
   - Power on the
FADEC (using a RX battery and receiver), and
select the apropiate COMM port in the menus.
(the one
which that USB adapter is set) |
|
   -Once you
select the appropriate COMM port, the software
will display "Fadec connection OK". |
| |
|
   3)
If you use a Xicoy (Nades) Electronica USB-FADEC
datacable: |
|
   -Download
the USB drivers file found at top of this page
in a temporary directory and unzip it.
|
   -Connect your
USB datacable to your computer. The PC will
detect it and will show a label "FADEC USB
DATACABLE",
and automatically will ask for the drivers.
Select the directory where you have un-zipped
the drivers, and wait for that the
installation be complete. |
   -Once the
drivers installed, you can launch the FADECV4
executable and connect the FADEC to the cable.
No power
needed. If the driver is correctly installed,
the main screen of the software will show "Fadec
connection OK" and
"Connected to USB". No comm port selection
needed. |
