Aeropoxy
Aerospace Grade

    The ever increasing aerodynamic stresses we expect our models to endure means its time for an aerospace grade adhesive product and AeroPoxy is it. AeroPoxy is a thixotropic, slow cure, aerospace grade, 2-part epoxy system. It is the strongest and best gripping adhesive we have found.

As good as Aeropoxy but cures in 1/2 the time.

Aeropoxy vs Vpoxy - the differences

  • Aeropoxy is white, Vpoxy is clear
  • Aeropoxy is totally thixotropic - i.e. it will not run or sag. Vpoxy is slightly less thixotropic - thus it may penetrate some materials better.
  • Aeropoxy initial setup time is about 3 hours at 75°F. Vpoxy initial setup time is about 1 hour at 75°F.
  • Technical data on the strength properties of both glues render them about the same.
  • Aeropoxy and/or Vpoxy are Aerospace grade adhesives and the strongest epoxy based glues available to the modeler.

It requires a 2:1 plunger if you already have an Aeropoxy dispenser gun.



 

   Thixotropic means that it will stay on the edge of a bulkhead or rib to ease the assembly process.  Finger wipe the
QT Poxy to form a uniform fillet.

   QT Poxy produces a bond that is almost as strong as BVM's Aeropoxy, but allows for quick assembly and field repairs.  Set time is 4 - 5 minutes.

 

Contact Us
All graphics and photos Copyright 2011 BVM, Inc.
Use of graphics or photos without written permission from BVM is strictly prohibited.